Home > ProductsThe 30 watts hot water thermoelectric power generator is good for waste heat recovery or geothermal heat.

The 30 watts thermoelectric generator runs with circulated 80 – 100 °C or less hot water which distributes the heat to each thermoelectric module (TEM) to generate electricity. The cooling of the generator is by using 30C or below cold water, which brings out the heat that passes through the modules effectively. The generator is good for waste heat recovery or geothermal heat.

The thermoelectric power generator consists of thermoelectric modules, hot water pipe for hot water circulating to bring the heat to each module, cold water pipe for water circulating to bring out the heat. The hot water flows from bottom of the generator to bring the heat to all the hot sides of the modules and out from the top cooled water outlet. The cold water flows from the cooling water inlet in the bottom, pass the modules cold side to bring out the heat that flows through the modules, and then out from the top cooling water outlet.

The generator is installed with 16 pcs 55 mm x 55 mm modules. It can generate over 30 watts if the hot water is over 90 °C and cold water is 30 °C with 3.5 liters/per minute flow rate.

Please down load the specification from here in PDF





无敌金刚返水 北京小赛车群微信群 今日斯诺克比分直播 斯诺克比分雪缘网 疯狂飞艇有什么开奖规律 电竞比分网下载 3D彩吧图谜 美的集团股票分析论文 29选7图表 南宁期货配资公司 云南11选5游戏规则 广东好彩1 福建11选5走势图删除 北京快中彩 上海十一选五走势图45期 浙江61开奖结果查 云南快乐十分开奖走势图云